The Generator Speed Controller ESD5500E Series Speed Control Unit is rugged enough to be placed in a control cabinet or engine mounted enclosure with other dedicated control equipment. If water, mist, or condensation may come in contact with controller, it should be mounted vertically. This will allow the fluid to drain away from the speed control unit.
TECHNICAL SPECIFICATIONS of ESD5500/ ESD5500E:
Isochronous Operation/Steady State Stability
± 0.25% or better
Speed Range/Governor
1K-7.5K Hz continuous
Speed Drift with Temperature
± 1% Maximun
IDLE Adjustment
160 ± 20Hz ~ 60% of set speed
Droop adjustment Min.(K-L Jumpered)
15Hz. ± 6Hz. per 1.0 A change
Droop adjustment Max.(K-L Jumpered)
400Hz. ± 75Hz. per 1.0 A change
Droop Adj. Max. (K-L Jumpered)
875Hz., ± 75Hz. per 1.0 A change
Droop Adj. Min. (K-L Jumpered)
15Hz., ± 6Hz. per 1.0 A change
Speed Trim Range
± 200Hz.
Remote Variable Speed Range
500 -7.5Hz. or any part thereof
Terminal Sensitivity
J: 100Hz., ± 15Hz/Volt @ 5.0 K Impedance
L: 735Hz., ± 60Hz/Volt @ 65 K Impedance
N: 148Hz., ± 10Hz/Volt @ 1Meg. Impedance
P: 10V DC Provide @ 20ma Max.
Speed Switch Adjustment Range
1000-10000Hz.
ENVIRONMENTAL:
Ambient Operating Temperature Range
-40°c to +85°c
Relative Humidity
up to 95%
Storage Temperature
-55°c ~ 90°c
Shock
20-100HZ 500mm/Sec.
INPUT POWER:
Provide
12 or 24V DC Battery Systems(Transient and Reverse Voltage Protected)
Polarity
Negative Ground(Case Isolated)
Power Consumption
50mA continuous plus actuator current
Actuator Current Range @ 25°c-(Inductive Load)
Min. 2.5 Amps, Max. 10 Amps continuous
Speed Sensor Signal
0.5-120 V RMS
Speed Switch Relay Contacts(N.O.and N.C.)
10Amp
PHYSICAL
Weight
650g
Note: The performance parameters in the frequency when measuring 4000Hz
